VIBRO METER VM600 CPU M 200-595-065-114/200-595-100-013 CPU Card

The VM600 CPU M 200-595-065-114/200-595-100-013 is a modular Central Processing Unit (CPU) card intended for use in Vibro-Meter's VM600 series of Machinery Protection System (MPS) and Condition Monitoring System (CMS) racks. Depending on the system requirements, the CPUM may be used alone in the rack (installed in the front card cage) or in conjunction with the corresponding IOC N Input / Output Card (installed in slot 0 of the rear card cage, directly behind the CPU M).

Over the years, we have grown into a trusted global supplier with operations centers in Xiamen, China and Hong Kong, China. Our business spans the globe, with most of our valued customers located in the Middle East, Europe, the UK, Asia, and the USA.

Application
Thermal/Nuclear Power Plants:
Monitors shaft vibration, bearing vibration, and axial displacement of turbine generator sets to prevent catastrophic accidents such as bearing damage or shaft bending.

Petrochemical/Refinery Plants:
Used in large centrifugal compressors and reciprocating compressors. By monitoring vibration trends, it enables a shift from "repair after an accident" to "predictive maintenance."

LNG/Natural Gas Compressor Stations:
In high-speed rotating environments, millisecond-level response speeds can quickly cut off power, protecting the multi-million dollar unit.

Large Steel Plants:
Used in core power equipment such as blast furnace blowers.

FAQ

Q1: Must MPC4 and IOC4T be used in pairs of VM600 CPU M 200-595-065-114/200-595-100-013?
A: Yes. MPC4 handles calculations and logic processing, while IOC4T handles physical signal inputs and relay outputs. They communicate via the VM600 rack backplane.
VM600 CPU M 200-595-065-114/200-595-100-013VM600 CPU M 200-595-065-114/200-595-100-013 be replaced while the system is running (powered on)?
A: The VM600 supports hot-swapping, but before replacement, ensure that the protection logic for that channel has been bypassed; otherwise, it may trigger false trips, causing factory shutdowns.

Q3: Why is the "Diag" light on the VM600 CPU M 200-595-065-114/200-595-100-013 flashing red?
A: This usually indicates a self-test failure. It could be due to firmware version mismatch, missing parameter configurations, or a hardware malfunction.

Q4: How do I modify alarm values (Alarm/Danger)?
A: You need to use the dedicated MPS (VibroSight) software, connected via the Ethernet or serial port on the front end of the rack.

Q5: Can this system be connected to the factory's DCS or PLC?
A: Yes. It can communicate via the 4-20mA analog output of the IOC4T, or via Modbus TCP/RTU communication through the CPUM module on the rack.

More products of 12 months warranty & brand new to consider 

Email: sales3@askplc.com    

Mobile(WhatsApp): 86-18150117685

12 months warranty & brand new

Disclaimer

Moore specializes in the supply of both new and surplus industrial components, backed by an ever-growing global sourcing network. Please note that any manufacturer names, trademarks, or brand logos featured on this site are the property of their respective owners and are used for identification purposes only. Their appearance does not indicate an official partnership, endorsement, or authorized distributorship. We operate as an independent provider of high-quality automation solutions.