GE IS420UCSCH1A-G-V0.1-A Controller Module

--- PLEASE CONTACT FOR DETAILS

Sales manager : Yuki Huang

Email : sales6@askplc.com

WhatsApp : +86 17359287459

--- Item specifics

The GE IS420UCSCH1A-G-V0.1-A is a compact, stand-alone, high-reliability industrial automation controller. Designed as a single-unit solution, its hardware architecture is completely fanless and batteryless, which eliminates typical mechanical failure points and drastically reduces long-term operational maintenance requirements. The device runs on a highly stable QNX Neutrino real-time operating system (RTOS) to safely execute time-critical and high-speed processing logic. It incorporates advanced Embedded Field Agent (EFA) technology, enabling secure connections to Predix cloud-based systems or local networks for real-time edge data streaming.

---Data Info

·Minimum Input Voltage18 V DC

·Maximum Input Voltage30 V DC

·Maximum Power Consumption: 31 Watts

·Nominal Input Current~1.1 A to 1.3 A

·Memory Size: 4 GB DDR3-1333 SDRAM

·Flash Storage: 40 GB SSD pSLC

·Physical Ethernet Interfaces: Equipped with multiple RJ-45 communication ports

---FAQ

Q1: What is GE's legacy in the industrial automation industry?

A1: GE (General Electric), founded by Thomas Edison in 1889, was a global leader in PLC systems, including the famous Series 90-70, PACSystems RX3i/RXi, and VersaMax I/O platforms. While GE's industrial automation division was acquired by Emerson in 2019, these products remain widely used in factories worldwide .

Q2: Does GE support hot-swapping of I/O modules?

A2: Yes, most GE PACSystems and VersaMax I/O modules support hot insertion (hot-swapping) when used with compatible Network Interface Units. This allows module replacement without powering down the entire system. However, always verify your specific NIU configuration before performing hot-swap .

Q3: What is the most common failure mode in GE PLC modules?

A3: Power supply aging (capacitor failure) and communication faults (Ethernet/Profibus dropouts).

Q4: What is GE's proprietary communication protocol for PLCs?

A4: GE developed SRTP (Service Request Transport Protocol) for Ethernet communication with PLCs, succeeding the serial SNP/SNPX protocols. It uses default port 18245 .

---About Our Company

✅Staying ahead for over 23 years, and counting.

✅We help keep the World's Production Running!

✅Approaching 2 Million Parts

✅Emergency Shipping Available

---More Items

Email : sales6@askplc.com

WhatsApp : +86 17359287459